Hydrotech's Monolithic Membrane 6125 (MM6125®) is installed at 2-3 times the thickness of many other liquid applied waterproofing membranes. The greater thickness of MM6125 allows for a wider variety of substrate conditions, increases its crack bridging capability and enhances its self-healing properties.

MM6125 is typically installed as either a Fabric Reinforced or Standard installation. A description of each installation method and a membrane selection chart follows...

Monolithic Membrane 6125 Fabric Reinforced Assembly...

The Monolithic Membrane 6125 Fabric Reinforced Assembly consists of one coat of membrane at 90 mils (2.3 mm) into which Hydrotech's Flex Flash F (a spunbonded polyester fabric) is embedded. A second coat of membrane is then installed at 125 mils (3.2 mm) minimum. Total membrane thickness is 215 mils (5.5 mm).

The Fabric Reinforced Assembly method of installation is typically used for poured-in-place and precast concrete substrates in "renovation/rehabilitation" work. It is also used for poured-in-place concrete substrates in "new construction" when a belt and suspenders approach may be desired. In addition, the Fabric Reinforced Assembly is used on plywood, wood plank and an approved cementitious board, over a metal deck substrate. (SEE CHART BELOW.)

Monolithic Membrane 6125 Standard Assembly...

The Monolithic Membrane 6125 Standard Assembly consists of one coat of membrane at a thickness of 180 mils (4.6 mm), minimum 125 mils (3.2 mm).

The Standard Assembly method of installation is typically used for poured-in-place and precast concrete substrates in "new" construction. (SEE CHART BELOW.)

Membrane Assembly Selection Chart...

Membrane Assembly and Acceptable Deck Chart

Substrate Type

Standard Assembly

Fabric Reinforced Assembly

Cast in-place concrete (wood troweled finish preferred)

(minimum density of 115 pcf)



Composite deck (concrete over metal)



Precast concrete: "T", Double "T", panel



Lightweight insulating concrete or cellular concrete



Wood Plank






Metal deck with gypsum board (or other acceptable cover board)






Separation/Protection Course...

On a horizontal installation a separation/protection course such as Hydrotech's Hydroflex 10 or Hydroflex 30 is embedded into the membrane while it is still warm and tacky, to provide protection from foot traffic and moderate physical abuse. On vertical installations a protection layer such as Dow STYROFOAM® Insulation board, Thermaflo® or other approved protection may be used.

Recent Press

  • May 21, 2018
    American Hydrotech, a recognized leader in the development and distribution of premium waterproofing and roofing assemblies, today announced the availability of their Protected Membrane Roof (PMR) Planning Guide , a unique, new resource representing...
  • February 1, 2018
    CHICAGO, ILLINOIS (February 1, 2018) The Chicago Blackhawks have captured the hearts of the city of Chicago along with three Stanley Cups in the last decade. The Blackhawks routinely lead the league in attendance at the United Center, and fans were...
  • October 18, 2017
    CHICAGO, ILLINOIS (October 11, 2017) American Hydrotech – a market leader in the development and distribution of premium waterproofing and roofing products and assemblies, today announced the introduction of the InstaGreen® GT-4 pre-vegetated tray,...
  • April 3, 2017
    Wind data is a critical issue to consider when building a new structure. An increase in the number of green roofs on buildings has driven a need for new wind design standards to be written for vegetative roofing assemblies. Richard Hayden discusses...
  • September 27, 2016
    (September 28, 2016) Washington State has always been considered a pioneer when it comes to the adoption of greener and more sustainable practices. One of the most sustainable practices is to reuse an already constructed building and enhance that...
  • July 16, 2016
    (July 16, 2016) Excerpt from an article in Forester Daily News Green roofs – also known as vegetated or garden roofs – are key green infrastructure elements and are being increasingly recognized for their “valuable ability to absorb, reduce, and...

Upcoming Events

  • June 21, 2018 to June 22, 2018

    2018 AIA Architecture Expo

    Javits Center – New York NY Event Details
  • September 24, 2018 to September 28, 2018

    2018 GRHC CitiesAlive Conference

    New York Marriott at the Brooklyn Bridge – Brooklyn NY Event Details
  • October 21, 2018 to October 22, 2018

    2018 ASLA Annual Meeting & EXPO

    Philadelphia PA Event Details